How To Check The Brake Pad Thickness Most Accurately?

There is no fixed cycle for the replacement of the brake pads. If you go to the 4S shop for maintenance, the staff will say that it is time to replace the brake pads without inspection, which is extremely irresponsible. Only the oil and filter elements on the car have a fixed replacement cycle. All other items must be checked to determine whether they need to be replaced. Today, the Hummer Brake Pad Manufacturer is talking about brake pads. Most people change mileage between 30,000 and 80,000 kilometers, and the mileage varies widely. It's early to change the brakes more often, and to run less frequently at high speeds, and change later. However, it is also related to the material of the brake pads, and some models are generally replaced earlier, which is caused by the brake pads being too soft.

If the vehicle is not maintained by itself, go to a 4S shop or a repair shop, and then let the technician check the thickness of the brake pads during each maintenance. It is not enough to drive until the next maintenance, and it should be replaced. If the car is maintained by itself, how do you check it yourself? Also look at the number of kilometers first. If the number of kilometers is small, less than 30,000 kilometers, you can take a look at it. If you flash it, you can see the thickness of the brake pads. If it is more than 30,000 kilometers, it is best to check it carefully. The method is to remove the tires and see at a glance. There are two brake pads on each wheel, one on the outside and one on the inside. If you only look at it with a flashlight from the outside, you can only see the outside. Most of the car's internal and external brake pads wear similarly, but some cars are quite different. If the inner piece wears to the limit and the outer wear has not reached the limit, then just looking at the outer piece is not allowed.

Ford USA Brake Pad

After removing the tires, the inner and outer brake pads can be clearly seen, and they are also accurate, because if you do n’t have much experience, if you look obliquely from the outside, the thickness judgment is not too accurate. Generally 3 millimeters are left to be replaced. If there are 5 millimeters after removal, it is best to take it apart for the next maintenance. If there is 1 cm, it means that the brake pads are still very thick, so you don't need to take it apart next time. There is an alarm pad on the brake pad. If it wears to the limit, it will make a sound with the friction of the brake disc, so if you forget to check the brake pad and make a sharp abnormal sound when you step on the brake lightly, you must pay special attention to it. Already.

The brake pads of most cars have fast front wheel wear and slow rear wheel wear. Almost twice the front rotation and one rear rotation. Because the center of gravity of the vehicle moves forward during braking, the braking force is concentrated on the front wheels, so it varies according to kilometers. Check the front wheels first. Of course, there are very few rear-wheel-drive vehicles that can cause considerable wear on the front and rear wheels and even fast rear wheels.

If you replace it yourself, it is best to buy branded parts from large manufacturers of good quality, and not to buy sub-factory parts of poor quality. The auxiliary factory parts are cheap, and the cost is definitely low, so the quality will be bad. Poor quality brake pads are poor in high temperature resistance. When the brakes are stepped down frequently, the temperature will be slightly lower, the performance will be greatly reduced, the friction will be reduced, and the braking force will be reduced. The brake pads with worse quality will also crack or even break and affect the driving safety. After replacing the brake pads, remember to step on the brakes of your two feet and drive the brakes after you have stepped on the brakes, otherwise it is very dangerous that the front two feet are not braked.

The above is Ford USA Brake Pad supplier introduces how to check the thickness of the brake pads.