Correct Maintenance Methods For Brake Discs And Brake Pads

As for the brake discs and brake pads, the old drivers are naturally too familiar with them: at 30,000 to 40,000 km, the brake pads are replaced, and at 60,000 to 70,000 km, the brake discs are replaced. The time here is completely changed, but many people do not know their daily maintenance methods! Car brake pads are very important on the car, after all, it is related to our safe driving, so how to maintain the car brake pads? Chevrolet Brake Pad Manufacturer will tell you next.

The brake pad is composed of a friction material layer, a heat insulation layer, an adhesive layer, a back plate and the like. The brake pad pushes the back plate through the brake cylinder to press the friction material of the brake pad against the brake disc for braking, so the quality of the friction pad is particularly important.

The first is to maintain the brake system products: spray type brake system and component cleaning agent, brake disc high temperature protection agent, brake guide pin and pump lubricant, brake hub lubricant protection agent and daily use sandpaper!

The main maintenance items are: high-temperature protection of brake pads, lubrication and maintenance of brake cylinders, cleaning of brake discs, and anti-rust lubrication of contact surfaces of tire screws, brake discs and steel rings, etc.! Of course, there is the replacement of the brake fluid.

The main maintenance steps of the brake pads are as follows:

1. Remove the wheels, brake pads and guide pins that need maintenance;

2. Use spray type brake system and component cleaning agent to clean the back of brake discs, brake hubs and brake pads, and allow them to air dry.

3. Use sandpaper to polish the front of the brake pads and the rust on the brake hub.

4. Evenly apply the high temperature protection agent of the brake disc to the back of the brake shoe;

5. Apply the brake guide pin and the pump lubricant to the brake guide pin and the pump shaft;

6. Apply the brake hub lubricant and protection agent on the surface of the brake hub;

7. After completion, reset the brake system and test to ensure that the brakes are normal.

The most direct way to maintain the brake pads is to replace them in a timely manner, whether it is Infiniti Brake Pad or BMW brake pads, but the issues that need attention during normal maintenance are also indispensable: First, the emergency brake brake has a great damage to the brake pads, so When driving normally, pay attention to slow braking, or use the point brake to brake, so the wear on the brake pads is relatively small. Then, when driving normally, you should develop the habit of reducing braking, that is, you can use the engine's brake to reduce the speed, and then use the brake to further slow down or stop. When driving, you can downshift more to achieve deceleration.

 Infiniti Brake Pad 

In addition, when the vehicle has traveled for 40,000 kilometers or more than two years, the brake pads are relatively worn out. You should carefully check and check regularly to see if the thickness of the brake pads has been reduced to the minimum limit value. If you reach the limit value, you must replace it. Brake pads. Under normal driving conditions, check the brake pads every 5,000 kilometers, not only to check the remaining thickness, but also to check the wear status of the shoe pads, whether the degree of wear on both sides is the same, and whether the return is free.

This kind of maintenance method is very simple, you can do it yourself at home! This also saves a lot of 4S shop inspection and maintenance and man-hour costs! Why not do it?

The above is the Ford USA Brake Pad supplier introduces how to maintain the brake pads. Hope to help you.